Wind Power

Ultra High-Pressure at Work During Wind Power Installations

Installing turbines for wind power requires ultra high pressure for accurate bolt loads. Turbines are usually installed in remote areas: on mountain tops, in the countryside or out at sea where conditions can be tough. Hence the need for high-performance tools during installation and subsequent maintenance work. With 40 years of experience in producing ultra high pressure couplings and hoses, CEJN has always focused on safety, delivering quality of the highest order for a safe work environment and fast installation.

Popular CEJN Products for Wind Power Installations

  • Series 115, High-Flow, 80 MPa

    DN 4 mm (5/32"). Flow capacity of 11 l/min (2.4 GPM UK). Max working pressure 80 MPa. Made of hardened zinc chromate plated steel...
  • Series 116 Flat-Face, 150 MPa

    DN 2.5 mm (3/32"). Flow capacity of 1.4 GPM (5.3 l/min). Max working pressure 21,750 PSI (1500 bar). Made of hardened zinc chromate plated steel...
  • Series 116 - 21,750 PSI (1500 bar)

    DN 2.5 mm (3/32"). Flow capacity of 1.58 GPM (6.0 l/min). Max working pressure 21,750 PSI (1500 bar). Made of hardened zinc chromate plated steel...
  • Series 116 T-Connection

    Series 116 T-Connection is a lightweight, one-piece coupling and nipple combination for making serial connections on high-pressure hydraulic tools, such as bolt tensioners and cylinders...
  • Hose Assemblies

    CEJN Ultra High-Pressure hoses for hydraulics are spiralized steel reinforced polymer that has ultra-high working pressure with maintained flexibility. Its low volumetric expansion give fast response...
  • Snap-Check / 358 - Quick Connect Pressure Testing

    The Snap-Check pressure testing system easily monitors and diagnoses fluid systems. It identifies operating pressure surges without the need for a permanently installed gauge. The maximum working...